This is a complete 4-gauge (4 AWG) battery cable set sized specifically for the Yamaha G22 48-volt golf cart. Over years of vibration, heat, and charge cycles, the original interconnect cables corrode at the lugs and develop resistance — which shows up as weak performance, batteries that don’t charge evenly, and excess heat at the terminals. Replacing the whole set at once restores clean, low-resistance connections across the entire pack.
Because the set is cut to the correct lengths and fitted with the proper lugs for the G22’s battery layout, it installs cleanly without splicing or improvising — far better for safety and conductivity than reusing aging or mismatched cables. Fresh 4-gauge copper cabling is one of the cheapest ways to recover lost range and power on an older 48V cart, especially when paired with a new set of batteries.
If you’re rewiring the pack as part of a battery replacement or troubleshooting uneven charging, our technicians can install the cable set and load-test the pack on-site.
Compatibility
- Yamaha G22 golf carts wired for 48V
- Complete interconnect cable set — correct lengths and lugs for the G22 layout
- 4-gauge (4 AWG) copper
- Doing a lithium conversion or a different model? Ask us to confirm the right cabling
Features & Specs
- Battery interconnect cable set for Yamaha G22, 48V
- 4-gauge (4 AWG) conductor for low-resistance, high-current flow
- Pre-cut lengths and terminal lugs matched to the G22 pack
- Replaces corroded, high-resistance original cabling
Installation Notes
Always disconnect the pack before starting and replace cables one at a time, matching each new cable to the position of the old one so the series wiring stays correct. Clean the battery terminals, seat the lugs flat, and torque the hardware to spec — loose or corroded connections are a leading cause of heat and lost performance. New to pack wiring? Our mobile techs will rewire and load-test the pack for you.